Menu

Ireland's sailing, boating & maritime magazine

Displaying items by tag: Winterising Your Boat

Equipment
Warps and ropes should be left somewhere dry, whilst fenders can be cleaned and stored safely. If a dinghy is carried on davits, one winter left hanging can equate to four seasons of normal wear, so take it home. The anchor, chain and warp should be hosed and checked for weaknesses, especially the shackles. If the VHF aerial can be dropped, do so, and tie it up to stop it whipping all winter. Finally, take all non-secured equipment with you.

When all this is done, relax in the knowledge that you’ll have a healthy boat to re-stock in the spring, and start planning your 2011 cruises.

Failure to Winterise the Engine - As we all now know, temperatures drop below freezing in Ireland during the winter. Inland waters are used to dealing with freezing issues, but residents of coastal areas are less likely to properly prepare their engines for freezing temperatures.

Failure to Drain Water from Sea Strainer - While taking steps to properly winterise your boat engine, take time to address your seawater strainer as well. Water lingering in the strainer can freeze and damage seals. Damage won’t be obvious until the spring when water starts to flood the bilges.

Failure to Close Seacocks - Boats being stored in-water should have their seacocks closed. Heavy rain falls can force thru-hull fittings below the water surface. Follow good management practices for maintenance of thru-hull fittings, ensure connecting hoses are in good condition, hoses are double-banded to barb hose fittings, and seacock valves are well exercised. If there are no seacock valves connected to the thru-hull fittings, the boat shouldn’t be stored in the water for the winter. The only exception to this rule are cockpit drains.

Leaving Open Boats in the Water Over Winter - Vessels with large areas exposed to the weather or that have low freeboard should be stored upland. Heavy rain fall or snow can force open scuppers, thru-hull fittings, or even the gunwhales below the water.

Using Bimini Covers as Winter Storage Covers - Bimini tops are meant to provide cover from the sun and aren’t designed to protect a boat from winter water. These fair-weather covers will fail prematurely and offer little protection for your boat. Consider the use of a “shrink wrap” covering system or tarps to keep rain and snow out of your vessel. Ensure there is good ventilation under the covers to reduce corrosion or fungal damage to the boat
Published in Boat Maintenance
15th October 2010

Getting it shifted

It’s good to know that there’s several sectors finding an increased demand for their services. For instance, boat transport is not always something that owners can do themselves, especially the movement of large boats. What might look small on water is normally huge on the road.

There is nothing more important than checking your lifejacket works but amazingly you will find elsewhere (pg4) in this issue about how many lifejackets failed a free check in Dun Laoghaire this summer. As with all safety and emergency equipment, servicing your lifejacket is most important. Whatever type of lifejacket you use, it will need basic maintenance to keep it working properly.

 

Whitten Road Haulage, with over 30 years of experience, feel that one aspect that sometimes overlooked is the ‘escort vehicle’ which alerts other road users and pedestrians of the imminent ‘abnormal load’. Tommy Lyndon says; “the escort vehicle, along with the occupants, should be equipped with 2-way radio systems, hazard warning and first-aid equipment”. They should also be in possession of awareness of legislation in various jurisdictions, which varies, and when an Abnormal Load Permit is required.

“In Ireland, the Abnormal Load Permit system is independently administered by each Local Authority and, accordingly, each journey will require separate application to each of the Council areas through which it is proposed to travel. Each application requires a different form, requesting different amounts of information, with different lead-in times and, of course, a fee in each case”, says Tommy.

Nigel Sands from Sands Marine would agree – he knows of two customers who bought boats in the UK which were put on the wrong trailer, the gauges weren’t working, and the trailer bent. To add insult to injury, the boat didn’t get a proper Pre-Delivery Inspection (PDI), and, as the local dealer, he got the call to sort it out. So buying abroad isn’t necessarily a money-saving exercise as the above would seem to show: for example, un-tested engines can be put into boats but the problem doesn’t become visible until the boat is far away from the seller. Dealing locally means you get the after-sales service that’s so crucial to a happy sailor.

Published in Boat Maintenance
15th October 2009

Winterising Your Boat

Winterising Your Boat

The whole idea of winterisation can be about as appealing as having a tooth filled – and possibly as expensive – but there’s no substitute for being prepared, and a reluctance to cough up the necessary budget can be a false economy in the long run.

Of course, winterisation is not a word that will stir much enthusiasm in the breast of the average boat-owner, bringing home the fact that summer is over and the evenings will now close in with unprecedented speed.

However, the W-word could be quite painless, even fun, if you are into that sort of thing. And most sailors love their boats – it being a source of pride and pleasure – and want to keep them in top condition.

This Afloat guide to winterising your boat (see menu on right hand side of page) will steer you towards those who can do the job for you, or at least give you useful advice so that you don’t end up standing in the dark, cold, wet, and frustrated, with oil on your clothes and an engine strewn all over the driveway.

It may be true that in the depths of winter lies an invincible summer.

Published in Boat Maintenance

Dublin Bay 21s

An exciting new project to breathe life into six defunct 120-year-old Irish yachts that happen to be the oldest intact one-design keelboat class in the world has captured the imagination of sailors at Ireland's biggest sailing centre. The birthplace of the original Dublin Bay 21 class is getting ready to welcome home the six restored craft after 40 years thanks to an ambitious boat building project was completed on the Shannon Estuary that saved them from completely rotting away.

Dublin Bay 21 FAQs

The Dublin Bay 21 is a vintage one-design wooden yacht designed for sailing in Dublin Bay.

Seven were built between 1903 and 1906.

As of 2020, the yachts are 117 years old.

Alfred Mylne designed the seven yachts.

The total voting population in the Republic's inhabited islands is just over 2,600 people, according to the Department of Housing.

Dublin Bay Sailing Club (DBSC) commissioned the boat to encourage inexpensive one-design racing to recognise the success of the Water Wag one-design dinghy of 1887 and the Colleen keelboat class of 1897.

Estelle built by Hollwey, 1903; Garavogue built by Kelly, 1903; Innisfallen built by Hollwey, 1903.; Maureen built by Hollwey, 1903.; Oola built by Kelly, 1905; Naneen built by Clancy, 1905.

Overall length- 32'-6', Beam- 7'-6", Keel lead- 2 tons Sail area - 600sq.ft

The first race took place on 19 June 1903 in Dublin Bay.

They may be the oldest intact class of racing keelboat yacht in the world. Sailing together in a fleet, they are one of the loveliest sights to be seen on any sailing waters in the world, according to many Dublin Bay aficionados.

In 1964, some of the owners thought that the boats were outdated, and needed a new breath of fresh air. After extensive discussions between all the owners, the gaff rig and timber mast was abandoned in favour of a more fashionable Bermudan rig with an aluminium mast. Unfortunately, this rig put previously unseen loads on the hulls, resulting in some permanent damage.

The fleet was taken out of the water in 1986 after Hurricane Charlie ruined active Dublin Bay 21 fleet racing in August of that year. Two 21s sank in the storm, suffering the same fate as their sister ship Estelle four years earlier. The class then became defunct. In 1988, master shipwright Jack Tyrrell of Arklow inspected the fleet and considered the state of the hulls as vulnerable, describing them as 'still restorable even if some would need a virtual rebuild'. The fleet then lay rotting in a farmyard in Arklow until 2019 and the pioneering project of Dun Laoghaire sailors Fionan De Barra and Hal Sisk who decided to bring them back to their former glory.

Hurricane Charlie finally ruined active Dublin Bay 21 fleet racing in August 1986. Two 21s sank in the storm, suffering the same fate as a sister ship four years earlier; Estelle sank twice, once on her moorings and once in a near-tragic downwind capsize. Despite their collective salvage from the sea bed, the class decided the ancient boats should not be allowed suffer anymore. To avoid further deterioration and risk to the rare craft all seven 21s were put into storage in 1989 under the direction of the naval architect Jack Tyrrell at his yard in Arklow.

While two of the fleet, Garavogue and Geraldine sailed to their current home, the other five, in various states of disrepair, were carried the 50-odd miles to Arklow by road.

To revive the legendary Dublin Bay 21 class, the famous Mylne design of 1902-03. Hal Sisk and Fionan de Barra are developing ideas to retain the class's spirit while making the boats more appropriate to today's needs in Dun Laoghaire harbour, with its many other rival sailing attractions. The Dublin Bay 21-foot class's fate represents far more than the loss of a single class; it is bad news for the Bay's yachting heritage at large. Although Dún Laoghaire turned a blind eye to the plight of the oldest intact one-design keelboat fleet in the world for 30 years or more they are now fully restored.

The Dublin Bay 21 Restoration team includes Steve Morris, James Madigan, Hal Sisk, Fionan de Barra, Fintan Ryan and Dan Mill.

Retaining the pure Mylne-designed hull was essential, but the project has new laminated cold-moulded hulls which are being built inverted but will, when finished and upright, be fitted on the original ballast keels, thereby maintaining the boat’s continuity of existence, the presence of the true spirit of the ship.

It will be a gunter-rigged sloop. It was decided a simpler yet clearly vintage rig was needed for the time-constrained sailors of the 21st Century. So, far from bringing the original and almost-mythical gaff cutter rig with jackyard topsail back to life above a traditionally-constructed hull, the project is content to have an attractive gunter-rigged sloop – “American gaff” some would call it.

The first DB 21 to get the treatment was Naneen, originally built in 1905 by Clancy of Dun Laoghaire for T. Cosby Burrowes, a serial boat owner from Cavan.

On Dublin Bay. Dublin Bay Sailing Club granted a racing start for 2020 Tuesday evening racing starting in 2020, but it was deferred due to COVID-19.
Initially, two Dublin Bay 21s will race then three as the boat building project based in Kilrush on the Shannon Estuary completes the six-boat project.
The restored boats will be welcomed back to the Bay in a special DBSC gun salute from committee boat Mac Lir at the start of the season.
In a recollection for Afloat, well known Dun Laoghaire one-design sailor Roger Bannon said: "They were complete bitches of boats to sail, over-canvassed and fundamentally badly balanced. Their construction and design was also seriously flawed which meant that they constantly leaked and required endless expensive maintenance. They suffered from unbelievable lee helm which led to regular swamping's and indeed several sinkings.

©Afloat 2020